Metal cutting fiber laser with covered workspace 1,300x900 mm

Screw compressors, type series ORL, are designed for continuous operation with fully automatic control system of compressor operation, depending on compressed-air consumption. They are compressors with one-stage screw unit, lubricated by oil. The oil tank is integrated directly into the compressor block. The block ensures additional features: oil pre-separation in the cabinet, fine separation, oil filtration, maintaining the minimum pressure, including filtration and regulation of air intake. The compressor block and the electric motor are anchored to the frame, which is elastic-mounted in the compressor body by rubber springs. The body is composed of the frame, which is enclosed by removable sound-proof panels. • The German-made compact screw block featuring long service life and high reliability • Motor with the efficiency class at least IE3 (Premium) • Radial-flow fan - Low energy consumption and reduced noise level - Optimal cooling-air flow - Increase in the life of oil, consumables and the compressor • Smart control system • The control system ORL 901 ensures a user-friendly interface for the access to all compressor parameters, warnings for service and other events • Sophisticated control modes and intelligent algorithms allow the compressor to adjust automatically to the required changes • For selected series: the option of the heat-exchanger installation to heat up warm service water by means of waste heat generated due to compression Power 132 m3/hr motor power 18500 W noise level 71 dB

Tigemma’s filtration equipment could be used in many industry sectors, like civil engineering and basically everywhere where emission reduction and environmental improvement becomes an issue. We recommend these devices to go with the fiber lasers with a worktables over 3000 x 1500 mm.
The whole machine is made of steel sheets covered with a polyurethane two-component coating for high quality protection of all metal parts. It is constructed as a compact unit with an integrated and very well noise protected fan that provides an air flow of up to 3650 m3 per hour. For lasers with the worktable of 4000 x 2000 mm we recommend an installation of a double filtration. This solution is made possible by the modular design of all Tigemma FSD units.
This filtration device is equipped with a fully digital control. According to pressure measurements in individual parts of the unit, the control performs regeneration of the individual filtration cartridges by pneumatic tapping. Particles released that way get collected in a tray at the bottom of the machine. Filtration units that are supplied with our lasers come mounted with filtration suitable for the needs of fiber lasers. Though, upon request we are able to design solution for other applications.
High quality of the used filter materials allows for the cleaned air to be returned back to the room thus reducing heating costs in winter. These units comply with governmental regulations. By the amount of dust particles, this piece of equipment is classified as a small unnamed source of pollution. The user of this machine is then obliged only to notify his/her regional environmental department.

Light blue goggles fitted with glass lenses with a special filter to prevent any damage to eyes from reflected laser beam. A case is included.
VLT 70%.

Protection level: DIR LB6 @ 1080 nm (+ DI LB4 @ 10600nm).
Further protection:
190-260nm: D LB8 IR LB4
815-1400nm: DIR LB3
850-1400nm DIR LB4
890-1400nm: DIR LB5
930-1400nm: D LB6 IR LB7
1400-3000nm: DI LN4